Tuesday 21 November 2017
  • AMPLIFIER HF2013DX-A

    AMPLIFIER HF2013DX-A

    Designed for all short wave amateur bands from 1.8 till 29.7 MHZ
  • AMPLIFIER HF2013DX-A

    AMPLIFIER HF2013DX-A

    Power output: 2000W in SSB and CW 1800 W in RTTY, AM and FM
  • 1
  • 2

HF2013DX

The linear amplifier HF2013DX-A is designed for all shortwave bands from 1.8MHz to 29.7MHz amateur (including WARC) and all operating modes. It is equipped with a ceramic tetrode FU728F (4CX1500B). HF2013DX is version manual. The amplifier compared to other similar products and powered with two distinct power supply (two phases) to avoid voltage drops, maintaining a lower cost compared to the competition which use a single transformer. All this makes it suitable for use in extreme conditions type Contest.  For the price and the possible purchase refer to the website of our e-commerce at the following LINK

Specifications

- Frequency coverage: Amateur bands 1.8MHz - 29.7 MHz including WARC
- Output Power: 2000 W in SSB and CW 1800 W in RTTY, AM and FM
- Driving Power: usually 60-73 W for a full output
- Input Impedance: 50 Ohm VSWR <1.5: 1
- Amplifier output: 17 dB
- Output Impedance: 50 Ohm unbalanced
- Maximum output SWR: 2: 1
- SWR protection: automatic switching to STBY, when reflected power is 350W or higher
- Intermodulation distortion: 32 dB below nominal output
- Harmonic Suppression: <-50 dBc
- Tuning: Manual
- Response speed: AUTO less than 0.5s within the same BAND Less than 3s if out of band
- Supported TRX-CAT: ICOM, ELECRAFT, KENWOOD, TEN-TEC, YEASU and ICOM transceiver protocol used by microHAM devices - CI-V ouput
- Tube: Ceramic FU728F tetrode (like un4CX1500B)
- Cooling: EBM centrifugal fan axial fan +
- Power supply: 2 x 2kw 230 VAC, 50 Hz one or two phases
- Transformers: 2 x 2.0 kVA toroidal transformer
- Protection circuits:
- - SWR too high
- - Anode current too high
- - Current screen too high
- - Mains current too high
- - Tuning erratp of 'power amplifier
- - Protection switching for high temperature
- - Soft start for protecting your fuses
- - Lock HF2013 when the top cover is open

To provide the best possible service this site uses cookies, including third parties. Continuing browsing the site you consent to their use